So after 2 days of screwing around, I decided to recreate the project in Vcarve 6.5, created the tap files and poof!!! Everything worked perfectly! Including the fluting gadget. I also tried running the fluting gadget, I can set the fluting offset from beginning and from the end, it makes no difference it always starts the flutes at the start point defined in the control panel. If I join the vectors in a group, create the tap file (no bit changes) it works except the position is always at the start point. This is particularly frustrating when you have 2 or more tap files to run, because of bitt changes, because each file overlaps the previous carved file. I can move the engraving and the aspire preview looks perfect, yet when the tap file is run, again it begins at the start point. Problem – When working in Aspire, creating tap file, the engraving ALWAYS begins at the start point specified in the control panel preferences. I’ll begin with my software and equipment setup. I have been working with this problem for two days and gone through countless dowel rods in testing. I am getting very frustrated using the 4th axis accessory. The following is my email to support at NWA and Vectric:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |